Rheem Ruud Induced Blower Motor

I had my furnace checked and was told the inducer motor assembly had to be replace because it was sticking. I seems like a fairly easy replacement (as long as safety precautions are taken) for considerably less money than a service company said they would charge. It seems as though it's a routine process. How difficult is it really to replace an Induced Draft Blower Motor for a RheemRuud furnace? Part is: Rheem Ruud 70-24157-03 3000 Rpm.

Related Posts:

• 
  To buy new furnace carrier or trane or rheem
  
  To Buy New Furnace: Carrier or Trane or RheemGreetings. I want to have furnace, coil and duct in the attic replaced with new ones. Details are: - Two story house in north New Jersey with Basement....
  


• 
  Table saw motor needed
  
  Table saw motor neededI have a Craftsmann table saw, model number 137.248880. The motor is shot and I need a replacement. The motor model number is RM871, 15 Amp, 5000 RPM. Thanks in advance for y...
  


• 
  Suspect bad inducer motor in gas furnace need help
  
  Suspect bad inducer motor in gas furnace - need helpI have a 373LAV (Horizonatal) Bryant Model Gas Furance (about twelve yrs old). The furnace works intermittenly, but usually doesn't work. I am g...
  


• 
  Ryobi mulchinator blower vac rgbv3100
  
  Ryobi Mulchinator Blower Vac RGBV3100I own a Ryobi Mulchinator Blower Vac RGBV3100. As of late it won't start. Before it would start but was very tough doing so. I know that this model of blower/v...
  


• 
  Rheem criterion ii runs constantly no heat
  
  Rheem Criterion II runs constantly, no heatHello, We have a Rheem Criterion II furnace, model RGPH-10EAMR, dating from 1997, running on propane. Just recently it started running all the time, blo...